John Sayers' Design Forum

John Sayers' Recording Studio Design Forum

A World of Experience
Click Here for Information on John's Services
It is currently Wed Oct 24, 2018 2:32 am

All times are UTC + 10 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Thu Feb 05, 2015 12:13 am 
Offline

Joined: Thu Jan 02, 2014 12:04 am
Posts: 46
Location: W 85 14.089 , N 29 41.685
I have soldiered 4 of these connectors and on the XLR part of the jack and the XLR ONLY (trs is fine) when I plug to xlr cables in to my live wire cable tester and connect them to the wall connectors on either side of the run pins 2 and 1 cold and shield respectively are showing a short on all 4 of them (but for XLR only TRS is fine). Is this normal? No other xlr connectors (NON combo) have this short so it not the XLR cables I'm using and the TRS does not have a shield short either. I have a hard time believing that I made the same short on all 4 connectors while soldiering everything else correctly so is this the way it should read or do I have bad batch of connectors?


Report this post
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 10 hours


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group